Zinc Alloy Awning Mount of Motor Side, it is an customized part applied to motor homes, the technology for this part is high pressure die casting, the difficulty for this part is the wall thickness, it is very small, and the allowed draft angle is very small, only 1 degree. From th……
[More] [inquiry]
Aluminum Alloy Die Casting Knead and knock Case A380 It is a part applied to suspension system, with the purpose to improve the stability, the comfort, the safety of driving. The part is auto part for famous motor corporation. The part have very good monthly demand, which is around 50k pie……
[More] [inquiry]
Aluminum Alloy Die Casting side cover YL102 It is a part applied to suspension system, with the purpose to improve the stability, the comfort, the safety of driving. The part is auto part for famous motor corporation. The part have very good monthly demand, which is around 10k pieces. ……
[More] [inquiry]
Aluminum Alloy Die Casting side cover ADC12, The material for this part is ADC12. During the die casting. Higher specific pressure is required, so that higher filling speed can be obtained.which is beneficial for alloy to overcome mold filling resistance.and effectively fill each pa……
[More] [inquiry]
Aluminum Alloy Die Casting Knead and knock Case YL102 It is a part applied to suspension system, with the purpose to improve the stability, the comfort, the safety of driving. The part is auto part for famous motor corporation. The part have very good monthly demand, which is around 10k pie……
[More] [inquiry]
Aluminum die casting parts of Material position device case&cover ADC12, the parts are used in the conveyer equipment on the motor facility, the part have 2 cavities, so on the mold, there will be many protrude from the surface, then while feeding the mold, as the injection gate is locate……
[More] [inquiry]
Aluminum die casting parts of Motor end cover A380, this part is used as engine housing on the auto facility, the part have 2 cavities, so on the mold, there will be many protrude from the surface, then while feeding the mold, as the injection gate is located at the bottom of the surface, so ……
[More] [inquiry]
Aluminum die casting parts of Motor end cover ADC12, this part is used as engine housing on the auto facility, the part have 2 cavities, so on the mold, there will be many protrude from the surface, then while feeding the mold, as the injection gate is located at the bottom of the surface, so……
[More] [inquiry]
Threaded Pivot Housing of Aluminum, the Wiper Mounting Head part is a kind of pivot housing on windscreen wiper system, which is applied to bigger buses, boat etc. The part looks almost the same to the part number L017200. The most important point to ensure the quality control for this p……
[More] [inquiry]
Threaded Pivot Housing of Aluminum, the Wiper Mounting Head part is a kind of pivot housing on windscreen wiper system, which is applied to bigger buses, boat etc. The part looks almost the same to the part number 421-1040. The most important point to ensure the quality control for this ……
[More] [inquiry]
Double Shaft Pivot Housing, the part is also a kind of pivot housing on windscreen wiper system, which is applied to bigger buses, boat etc. The part is similar to the pivot housing 421-1034 but have two long pins, this pivot side housing have two long threaded pillars, from these two pi……
[More] [inquiry]
Single Shaft Pivot Housing, the part is also a kind of pivot housing on windscreen wiper system, which is applied to bigger buses, boat etc. The part is similar to the pivot housing 421-1034, this pivot side housing have a long threaded pillars, from the pillar, there to be one shaft ass……
[More] [inquiry]
